Very inspiring work and awesome presentation, many thanks for the share Keith!
The titles on the Presets and animation panels are showing super big. How can I resize them so they look normal? seems like a resolution issue. I’ve attached a screenshot for reference.
Could you tell me how to open that Presets dialog and I’ll look into it. All the rest of the UI is holding up nicely for me but I can’t find that dialog in the screengrab.
It’s the preset control panel Ben, you’ll just need to press any green button (labeled “C”) in the top left corner of any control panel to bring it up.
Wicked! Thank you. I’m new to TD, well I’m just about to purchase it, so was looking for an interface just like this to get rolling with it as soon as I get it. Luminosity looks sexy.
The scale/units of the projection setup is arbitrary. You can work in meters or feet, ie 1 == meter or 1==foot.
The only issue would be the actual projector size in the previs, since most of the projects I’ve been involved with were specced in feet the projectors are approximately 2*3 units which would be very large in meters…
It only matters visually in the previs though since all proj measurements are taken from the tip and center of the lens. You can relatively easily modify the projector size if needed as well.
yup i’m catching up the recording of the presentation in youtube, witch i’ve seen live, but didn’t remember that you’ve mentioned the inches / meters part!
Finally i did open a node and tha second monitor got fill with some image… not that one which i trigger but finally i saw something in a output monitor.
I just tryng from a non-commercial licenced 099 TD, and i must to supossed that there exist some restriction using Luminosity?
It looks like Luminosity uses Shared Mem Out CHOP which isn’t supported in the non-commercial version. I get red/blue checkerboards inside each of my channels.