Problem with art-net on 099

Hello! i have a project done with 088 to control leds, but it doesn´t work on 099… i dont see many difference about DMX by art-net soo i don´t know why is not working…

modelo 088 (Digital LED Stripe RGB SK9822 30 per meter 36w) .toe (5.84 KB)

Thanks!

There are quite a few differences in the DMX Out CHOP. Could you try to create a new DMX Out CHOP in 099 and use it (basically resetting the parameters and starting fresh)?

Hello Ben!

I did what you said, and still not working, also do it from scratch and nothing at all, very wierd?

any other idea?

thanks soo much

Javo

I did also another stup to send data from 099 to 088 with touchout/in and works anly on dmx out chop in 088, soo the problem is to configure dmx out chop in 099, but there is not much info about that changes in new version and how to setup now…

derivative.ca/wiki099/index. … X_Out_CHOP

version 088:

version 099:


Thanks!

Javo

This might be a silly question, but can you check to make sure Windows firewall isn’t block outgoing connections from 099, whereas maybe it isn’t for 088?

mmmm didn´t think about that, but how can allow 088 and block 099? anyway i think i have Windows firewall off. I will check it tomorrow.

thanks Elburz

You can check through this route:
winaero.com/blog/allow-block-ap … indows-10/

I did it and check it again but still not working for 099 and working for 088…

:frowning:

i don´t know why but after make the project again (9º try!!) it works!

:astonished:

Thanks Elburz for your time!

modelo 099 (Tira de leds digital RGB UC1903 - 30 leds metro).toe (3.98 KB)