Any advice on making Touch Out/In run faster? I have two fast computers communicating over a 1Gb switch and I can’t seem to get clean video above 320x240. It runs fine for a few seconds, freezes up for a second, and then repeats the cycle.
Thanks,
Michael
If you send it to the same machine is the performance better? That’s a good test just to make sure something it’s not something to do with the network.
Hi there, i’ve tried to send 2 different streams of Touch out from one machine to another using different ports for each stream. On the second machine, first stream is working fine but the second one is black. Is it some limitation? Can i sand more than one touch out?