2017.31700 099
x64
win 10
Hey I have managed to isolate a phenomenon I’ve not fully tracked down but experienced for a while to a specific issue.
I have a panel COMP, and I am moving the mouse around in it and the u/v values are in a chop.
Then, I have an execute DAT (same result with chop execute) which attempts to write the u/v chop values to a table.
Then I convert this table of values to a chop, then I multiply it to 0 with a math chop.
Then I put a null with selective cook after this assuming it will control cooking to only when the value changes. However this seems to be broken in this scenario.
Is this in some way intended or correct behavior? or perhaps a bug?
Thanks! Full example attached.
selectiveCook_brokenWithDatToChop.1.toe (4.86 KB)